# Service bulletin 17NA311

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10134585
- Published by NHTSA: 2018\-04\-23
- Manufacturer's number: 17NA311
- Manufacturer's date: 2017\-10\-24
- NHTSA component: POWER TRAIN:AXLE HUBS

## NHTSA's summary

This technical bulletin provides a procedure to replace the propeller shaft hub clamp bolt to correct a condition of a rattle type noise due to the propeller shaft hub clamp bolt coming loose.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2017/MC-10134585-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2017/MC-10134585-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Transmission and driveline, Axle

## Vehicles listed

- 2016 to 2017 CHEVROLET CORVETTE

## Other bulletins for the same vehicles and component

- [PIP5168F](/bulletins/10129067.md), 2018-02-21, Service bulletin: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT; BACK OVER PREVENTION; FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a no crank concern. Technician will need to check the valve train for movement when the engine is cranked. If the valve train is not moving while the crankshaft is moving the front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the valve train is rotating during inspection, disconnect the Camshaft Position sensor and check if the engine will start. If the engine starts front cover will need to be removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly. If the engine does not start with the Camshaft Position sensor disconnected the follow published \“Engine Cranks But Does Not Run\” diagnosis in Service Information. Also perform an Engine Compression Test and Cylinder Leakage Test in Service Information documents all results. If the Service Information procedures above isolate an engine mechanical concern then removed to inspect for a sheared cam sprocket locator pin. If the cam sprocket locator pin has sheared, replace the engine assembly.

JSON: [/v1/bulletins/10134585](/v1/bulletins/10134585)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%2017NA311&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10134585&vehicle=Service%20bulletin%2017NA311)