# Service bulletin T\-SB\-0084\-08 Rev

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10133791
- Published by NHTSA: 2018\-04\-23
- Manufacturer's number: T\-SB\-0084\-08 Rev
- Manufacturer's date: 2013\-03\-20
- NHTSA component: POWER TRAIN

## NHTSA's summary

Some 2008 ? 2011 model year Land Cruiser vehicles may exhibit a MIL ?ON? condition with transmission performance DTCs such as P2714, P0751, P0756, P0761, P0766, P0729, P0781, P0894, P2757, or P0776 and/or abnormal transmission shifting. Revised Engine Control Module/ECM \(SAE term: Powertrain Control Module/PCM\) software logic has been developed to address this condition. In some cases, replacement of the automatic transmission may also be required.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2013/MC-10133791-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2013/MC-10133791-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Transmission and driveline

## Trouble codes named

P0729, P0751, P0756, P0761, P0766, P0776, P0781, P0894, P2714, P2757

## Vehicles listed

- 2008 to 2011 TOYOTA LAND CRUISER

## Other bulletins for the same vehicles and component

- [T\-SB\-0134\-16\-Rev](/bulletins/10164330.md), 2019-09-03, Service bulletin: POWER TRAIN; ELECTRICAL SYSTEM; ENGINE. TSB: REVISION NOTICE July 01, 2019 Rev2: ? Applicability has been updated to 2019 ? 2020 model year Toyota vehicles. ? The Techstream Preparation and Process Overview sections have been updated. October 30, 2017 Rev1: ? Applicability has been updated to include 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T\-SB\-0012\-13. Service Bulletin No. T\-SB\-0012\-13 is obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding. Flash reprogramming allows the Electronic Control Unit \(ECU\) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field\-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System \(TIS\) and the Calibration Update Wizard \(CUW\). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. NOTE ECU is a Toyota term used to describe integrated computerized devices responsible for managing the operation of a system or subsystem. For the purposes of this bulletin, the term ?ECU? is used as a generic label for the following SAE J1930 standard references: ? Powertrain Control Module \(PCM\) ? Engine Control Module \(ECM\) ? Transmission Control Module \(TCM\) ? Any other Toyota specific control unit
- [T\-TT\-0086\-11](/bulletins/10134454.md), 2018-04-23, Service bulletin: POWER TRAIN. TechTip: Condition \- The vehicle may be difficult to start or have an abnormally low or rough idle after the battery has been disconnected or power to the Engine ECM has been interrupted.
- [T\-SB\-0237\-12](/bulletins/10133934.md), 2018-04-23, Service bulletin: POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE \(TCM/PCM/TECM\). Some 2008 ? 2011 model year Land Cruiser vehicles may exhibit a harsh shift on acceleration below 20 mph during the 2\-1 downshift. The Engine Control Module/ECM \(SAE term: Powertrain Control Module/PCM\) calibration has been revised. Use the following repair procedure to address this condition.
- [T\-SB\-0391\-08 Rev](/bulletins/10133836.md), 2018-04-23, Service bulletin: POWER TRAIN. This bulletin contains general vehicle pulling diagnosis and repair procedures along with specific information to help correct pulling complaints.
- [LSC BST Phase 3](/bulletins/10133773.md), 2018-04-23, Service bulletin: POWER TRAIN. As part of the settlement described above, Toyota will install Smart Stop Technology on the above listed model and model year vehicles. This feature will cut engine power in case of simultaneous application of both the accelerator and brake pedal at certain speeds and in certain driving conditions.
- [T\-SB\-0071\-11 Rev](/bulletins/10132084.md), 2018-04-02, Service bulletin: POWER TRAIN. The purpose of this service bulletin is to provide precautions to follow when installing an automatic transmission/transaxle assembly to avoid MIL ?ON,? shifting issues, and/or transmission damage. Use the information in this bulletin when installing an automatic transmission/transaxle assembly
- [T\-SB\-0200\-08 Rev](/bulletins/10109493.md), 2017-08-01, Service bulletin: POWER TRAIN:AUTOMATIC TRANSMISSION. TSB: The purpose of this bulletin is to assist in the identification and location of serial numbers on 2006 \- 2014 model year automatic transmissions.
- [T\-SB\-0134\-14](/bulletins/10109492.md), 2017-08-01, Service bulletin: POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. TSB: The purpose of this bulletin is to provide precautions to follow when installing an automatic transmission/transaxle assembly to avoid MIL "ON" shifting issues and/or transmission damage. Use the information in this bulletin when installing an automatic transmission/transaxle assembly.
- [T\-SB\-0260\-08 Rev](/bulletins/10109408.md), 2017-08-01, Service bulletin: POWER TRAIN:AUTOMATIC TRANSMISSION. TSB: The purpose of this bulletin is to assist in the identification and location of serial numbers on 2006 \-2014 model year remanufactured automatic transmissions.
- [T\-SB\-0049\-11 Rev](/bulletins/10109405.md), 2017-08-01, Service bulletin: POWER TRAIN; EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION. TSB: The purpose of this bulletin is to provide information regarding transmission and/or park neutral position switch installation. If the manual shift lever is rotated prior to installing the park neutral position switch, the detent spring may become detached from the manual shift lever.

JSON: [/v1/bulletins/10133791](/v1/bulletins/10133791)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20T-SB-0084-08%20Rev&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10133791&vehicle=Service%20bulletin%20T-SB-0084-08%20Rev)