Service bulletin E0N_LSC_Dealer L
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10132794 |
| Published by NHTSA | 2018-04-02 |
| Manufacturer's number | E0N_LSC_Dealer L |
| Manufacturer's date | 2014-06-04 |
| NHTSA component | FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: RADAR |
NHTSA's summary
Dealer Letter: The Pre-Collision System (PCS) uses a radar sensor to determine the possibility of a frontal collision. FCC regulations require the radar sensor to be temporarily inactive while the vehicle is stopped. Due to a program error in the Driving Support ECU, if the radar sensor is inactive for 10 seconds or more, the PCS may not reactivate on certain 2011-2014 Model Year Sienna vehicles equipped with PCS.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance
| TOYOTA SIENNA | 2011, 2012, 2013, 2014 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| TTT063620 | 2022-06-21. Service bulletin. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions |
|---|---|
| T-SB-0088-21 | 2021-11-15. Service bulletin. TSB: For proper calibration of the millimeter wave radar sensor, the vehicle and radar target must be on a level surface with a consistent plane. If a level surface with a consistent plane is not available, use the Floor Slope Compensation Procedure in this service bulletin in conjunction with the appropriate model and model year Repair Manual instructions when adjusting the millimeter wave radar sensor. |
| T-TT-0636-20 Rev | 2021-04-19. Service bulletin. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions. |
| T-TT-0636-20 | 2021-02-16. Service bulletin. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions. |
| T-TT-0603-20 | 2020-04-20. Service bulletin. TT: For proper calibration of the millimeter wave radar sensor, the vehicle must be on a level surface. If a level surface is not available, this tech tip should be used in conjunction with the repair manual to set the angle of the front millimeter wave radar sensor and reflector height before performing beam axis adjustment. |
| T-TT-0010-10 Rev | 2018-04-02. Service bulletin. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft. |
| E0N_LSC_Region L | 2018-04-02. Service bulletin. Region Letter: The Pre-Collision System (PCS) uses a radar sensor to determine the possibility of a frontal collision. FCC regulations require the radar sensor to be temporarily inactive while the vehicle is stopped. Due to a program error in the Driving Support ECU, if the radar sensor is inactive for 10 seconds or more, the PCS may not reactivate Pre-Collision Braking on certain 2011-2014 Model Year Sienna vehicles equipped with PCS. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |