Service bulletin PM700
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10123359 |
| Published by NHTSA | 2017-11-14 |
| Manufacturer's number | PM700 |
| Manufacturer's date | 2017-10-13 |
| NHTSA component | ENGINE AND ENGINE COOLING |
NHTSA's summary
Radiator Fan Dealer Inventory *****Dealer Announcement***** Nissan is conducting a quality action to inspect the date code on the cooling fan blade and, if necessary, replace the cooling fan shroud and motor assembly on 159 specific 2017 Sentra vehicles. Affected vehicles are not subject to stop sale and are either currently in dealer inventory or assigned and in transit to the dealer. Nissan requests dealers to inspect and, if necessary, remedy the affected vehicles prior to sale to help ensure customer satisfaction. *****What Dealers Should Do***** 1. Verify if vehicles currently in new dealer inventory are affected by this quality action using Service Comm or DBS National Service History ? Open Campaign I.D. PM700 - New vehicles in dealer inventory can also be identified using DBS (Sales-> Vehicle Inventory, and filter by Open Campaign). - Refer to NPSB 15-460 for additional information - Please continue to check newly arriving inventory for campaign applicability. 2. Use the attached procedure to inspect the vehicle and, if necessary, repair. 3. The service department should submit the applicable warranty claim for the action(s) performed so it can be closed on Service Comm and release the vehicle. ***** Dealer Responsibility ***** It is the dealer?s responsibility to check Service Comm or DBS National Service History - Open Campaign using the appropriate campaign I.D for the inspection status on each affected vehicle currently in new vehicle inventory. Nissan requests dealers to perform this repair on new vehicles in inventory prior to being retailed to help ensure customer satisfaction.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Engine
| NISSAN SENTRA | 2017 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| NTB22-026 | 2022-06-08. Service bulletin. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” (fuel pump assembly). The fuel level sensor can be replaced separately. • P0460 (FUEL LEV SEN SLOSH) • P0461 (FUEL LEVEL SENSOR) • P0462 (FUEL LEVL SEN/CIRC) • P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back. |
|---|---|
| NTB15-049X | 2022-05-20. Service bulletin. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB17-082E | 2022-03-12. Service bulletin. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB13-097J | 2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB13-027C | 2022-03-12. Service bulletin. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB18-077C | 2021-07-12. Service bulletin. MIL ON WITH DTC P0776, P1715 AND MAY HAVE HESITATION AND/OR LACK OF POWER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB16-018D | 2021-05-08. Service bulletin. MIL ON WITH P0603 STORED FOR ECM BACK UP CIRCUIT This bulletin has been amended. See AMENDMENT HISTORY on page 3. Please discard previous versions of this bulletin. |
| NTB20-082A | 2021-04-13. Service bulletin. 2016-2019 SENTRA; ENGINE NO CRANK/NO START This bulletin is no longer active. Please discard previous versions of NTB20-082. |
| NTB21-004 | 2021-02-06. Service bulletin. 2013-2019 SENTRA AND 2013-2021 NV200/TAXI; INDIVIDUAL FUEL PUMP SERVICE PARTS SERVICE INFORMATION If the “fuel level sensor, fuel filter and fuel pump assembly” (fuel pump assembly) needs to be replaced, due to an in tank fuel level sensor issue or fuel temp sensor DTC, the fuel level sensor (includes fuel temp sensor) can be ordered separately from the fuel pump assembly. • Refer to the Electronic Service Manual (ESM) for the service procedure to remove the fuel pump assembly. Sentra: PDF ESM – ENGINE > FL – Fuel System > MRA8DE (or) MR16DDT > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUP ASSEMBLY > Removal and Installation. Web based ESM – ENGINE > FUEL SYSTEM > MRA8DE (or) MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY. NV200 and Taxi: PDF ESM – ENGINE > FL – Fuel System > MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY > Removal and Installation. Web based ESM – ENGINE > FUEL SYSTEM > MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY> Removal and Installation. |
| NTB20-082 | 2020-12-09. Service bulletin. 2016-2019 SENTRA; ENGINE NO CRANK/NO START IF YOU CONFIRM The engine will not crank when pressing the push-button ignition switch and applying the brake pedal. • ACCESSORY and IGNITION ON modes can be turned on and off with the no start condition present. • The stop lamps will be inoperative with the no-start condition present. ACTION Install a new brake lamp switch and install a rubber grommet with the parts listed in PARTS INFORMATION on the last page of this bulletin. |