Service bulletin A961377 2035047-

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

NHTSA's summary

Supersedes Technical Service Bulletin Group 96 number 13-72 dated August 26, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative when the vehicle is driven in slowmoving stop-and-go traffic, especially on roads with multiple lanes. The message "Audi side assist unavailable: Sensors blocked" appears in the driver information system. The system is able to be activated approximately ten minutes after the traffic condition is removed, or after an ignition cycle. Audi Lane Change Assistant can be activated without issue. No obstructions can be found. DTCs are stored in the Lane Change Assistance control module. The control module mounting brackets are securely fastened to the lower rear bumper, and no damage is found to the rear bumper area, on the inside or outside. (If any damage is found, it is not covered under warranty.) The control module mounting brackets are not broken or loose. If a loose bracket is found, repair as necessary using the Elsa Repair Manual. Submit a separate warranty claim, as this TSB does not cover this repair.

The document

• NHTSA's copy of the document (PDF)
• If that address does not open, try this one

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance

Listing a model year does not mean every vehicle of it is concerned: the document says which.

• Bulletins for another vehicle
• Report an error on this page
• Report an error by email