Service bulletin PS512

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10115237
Published by NHTSA	2017-08-15
Manufacturer's number	PS512
Manufacturer's date	2017-07-14
NHTSA component	EQUIPMENT ADAPTIVE/MOBILITY

NHTSA's summary

PITSTOP: QUICK START GUIDE (QSG) DISCOLORATION - Some 2017-2018MY Forte (YDm) vehicles may experience some fading/discoloring (yellowing) of the Quick Start Guide (QSG) installed prior to delivery to your dealer. In the event you encounter this issue, a replacement QSG can be ordered and shipped to your dealer in maximum quantities of five (5) per order, at no charge. Overnight shipping is available at an additional charge to the dealer. When placing your order, reference the part number (A) listed on the back of QSG.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Equipment and accessories

Vehicles listed
KIA FORTE	2017, 2018

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
TSB_ENG222_R4	2021-12-23. Service bulletin. TECHNICAL SERVICE BULLETIN: EXCESSIVE OIL CONSUMPTION NU/GAMMA/THETA/KAPPA ENGINES - This bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information on diagnosing and/or repairing some 2011-2021MY vehicles (refer to the tables on pages 8-9 for applicable models and engine), which may exhibit a symptom of excessive oil consumption.
SC203_POC	2021-11-02. Service bulletin. SC203_POC: PROOF OF CORRECTION CARD
SC203_STKR	2021-11-02. Service bulletin. SC203_STKR: VOLUNTARY EMISSIONS SERVICE CAMPAIGN COMPLETION STICKER
SC203_TSB	2021-11-02. Service bulletin. VOLUNTARY EMISSIONS SERVICE CAMPAIGN: ECM UPDATE FOR OBD LOGIC IMPROVEMENT (SC203) - This bulletin provides the procedure to improve the logic of the Engine Control Module (ECM) on some 2017-2018MY Forte (YDm) vehicles equipped with the NU 2.0L MPI engine, produced from May 27, 2016 through June 27, 2018. While this issue has no effect on the drivability of the vehicle, nor does it release any air pollutants, the vehicle may fail a SMOG check and/or may not illuminate the Malfunction Indicator Light (MIL) for certain fuel system failures. In order to improve On-Board Diagnostics (OBD) logic, apply the improved software logic to the Engine system using the KDS ECU Upgrade function as described in this bulletin.
TSB_TRA083	2021-01-06. Service bulletin. TECHNICAL SERVICE BULLETIN: 7-SPEED DCT JUDDER INSPECTION AND DUAL CLUTCH ASSEMBLY REPLACEMENT - This bulletin provides the procedure to replace Dual Clutch Assembly and upgrade the TCU on some 2016-2020MY Kia vehicles listed on the table below, equipped with the 7 Speed Dual Clutch Transmission (DCT), which might exhibit clutch judder when accelerating from a stop. If the vehicle body vibrates without the steering wheel shuddering when performing creep driving test (driving the vehicle up to 3mph), the vehicle is exhibiting clutch judder. The creep test can be conducted by driving at a speed slower than 5 mph after releasing the brake.
PS675	2020-09-03. Service bulletin. PITSTOP - BRAKE CALIPER LEAK INSPECTION - This PITSTOP provides information related to a brake caliper fluid/oil substance found on some Kia vehicles, due to possible excess assembly oil applied during assembly.
TSBCHA084_R4	2019-12-09. Service bulletin. TECHNICAL SERVICE BULLETIN: PARTIAL REPAIR OF C-MDPS MOTOR, ECU AND/OR STEERING COLUMN HOUSING - This bulletin has been revised to include additional information.This bulletin provides information regarding the partial repair of the Motor Driven Power Steering (MDPS) Motor, Electronic Control Unit (ECU) or Steering Column Housing on some 2010MY~ Kia models listed on page 5 equipped with a Column Motor Driven Power Steering (C-MDPS) unit. Follow the MDPS Flowchart (page 2) along with the MDPS DTC Table (page 3) procedure outlined in this bulletin before replacing the C-MDPS Motor, ECU or Steering Column Housing.
TSBELE159	2019-04-30. Service bulletin. TSB: STEERING WHEEL MOUNTED AUDIO CONTROL MALFUNCTION - This bulletin provides the procedure to inspect and, if necessary, replace the clock spring assembly on some 2014-2018MY Forte (YD/YDm) vehicles, produced from February 20, 2013 through June 30, 2018, which may experience intermittent malfunctioning steering wheel audio controls due to a clock spring connector pin deformation, with no related DTCs for this concern. Note: this does not impair the clock spring airbag function. Follow the procedure in this bulletin to inspect the clock spring female connector and, if necessary, replace the clock spring assembly.
TSBCLI044	2019-04-06. Service bulletin. TSB: SERVICE ACTION: A/C REFRIGERANT OVERFILL (SA372) - This bulletin provides the procedure to recover and recharge the air conditioning system on certain 2019MY Niro Hybrid (DE HEV) and Niro Plug-in Hybrid (DE PHEV) vehicles, produced from July 9, 2018 through December 21, 2018, which may experience poor air conditioning performance due to a possible overfill of refrigerant. Follow the procedure in this bulletin to recover and recharge the air conditioning system with the proper amount. Kia is requesting the completion of this Service Action on all affected vehicles including dealer stock, prior to delivery.
PS067_R1	2018-11-13. Service bulletin. PITSTOP: CYLINDER HEAD STEEL BALL INSPECTION AND INSTALLATION - This Pitstop provides information regarding the inspection and installation of the steel sealing ball on: * 3.3L & 3.8L Lambda engines for 2007-2008MY Sorento (BL), * 2.0L Nu engines for 2010-2019MY Soul (AM, PS), and * 1.8L & 2.0L Nu engines for 2010-2018MY Forte (TD, YD/YDm), 2019MY~ Forte (BDm). When replacing the cylinder heads on these engines, inspect the lubrication ports for installation of the steel sealing balls. Current replacement cylinder heads may not be equipped with the required steel balls. Identify and locate the nine (9) lubricant passages on 3.3L and 3.8L engines and three (3) on 1.8L and 2.0L engines and verify a steel ball is installed in each.