# Service bulletin SA\-049\-17

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10111022
- Published by NHTSA: 2017\-08\-10
- Manufacturer's number: SA\-049\-17
- Manufacturer's date: 2017\-06\-13
- NHTSA component: ELECTRICAL SYSTEM:IGNITION; EQUIPMENT:ELECTRICAL

## NHTSA's summary

There are a few issues with the accessory C960\-V7\-620 remote start kit instructions. In the current ?Registration \(programming\) of the controller? instructions, step 5shows an incorrect image. The function button is the lower button. The correct set of instructions are below. The instructions for registration of additional remotes is not available on the E\-catalog web site at this time. The instructions are below. A troubleshooting guide is not available on the E\-catalogs web site at this time. The instructions are below.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2017/MC-10111022-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2017/MC-10111022-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Electrical system, Equipment and accessories, Ignition

## Vehicles listed

- 2017 MAZDA CX\-5
- 2017 MAZDA CX\-9

## Other bulletins for the same vehicles and component

- [05\-001\-19\-3538](/bulletins/10154450.md), 2019-03-11, Service bulletin: ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:IGNITION. When pressing the START/STOP button in very cold weather, the ignition may not turn off on some vehicles equipped with a lock release button \(1\) on the selector lever knob. Although the selector lever is in the "P" position and the engine shuts off normally, the ignition may stay on \(in accessory mode\). NOTE: This TSB only applies if the selector lever knob is BHN2\-46\-030\* or BHN4\-46\-030\* with the lock release button. If not, this TSB does not apply. This may be caused by the lock release button in the selector lever knob sticking in the pressed position. An improper production process is causing an internal part to expand with moisture and interfere with other parts. To eliminate this concern, the production process has been modified.

JSON: [/v1/bulletins/10111022](/v1/bulletins/10111022)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20SA-049-17&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10111022&vehicle=Service%20bulletin%20SA-049-17)