Service bulletin 09-009-17-3302
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10111012 |
| Published by NHTSA | 2017-08-10 |
| Manufacturer's number | 09-009-17-3302 |
| Manufacturer's date | 2017-03-13 |
| NHTSA component | ELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM) |
NHTSA's summary
Some vehicles may exhibit navigation unit that cannot read out SMS (Short Messages Service) or does not operate properly after reading SMS. These concerns may be caused by problems with the Bluetooth Unit software.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Equipment and accessories, Software
| MAZDA CX-5 | 2013, 2014, 2015 |
|---|---|
| MAZDA CX-9 | 2013, 2014, 2015 |
| MAZDA MAZDA3 | 2013 |
| MAZDA MAZDA6 | 2014, 2015 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 09-007-18-3422 | 2018-05-07. Service bulletin. Some customers may experience a navigation system screen that shows the wrong location. This concern is due to poor reception of the GPS signals. To eliminate this concern, the CMU hardware has been modified. |
|---|---|
| SA-017-18 | 2018-04-23. Service bulletin. Upgrade your PCs to IDS version 109.00 and 109.01 from the previous version. NOTE: You may see ?Selection not available? on IDS when a selecting ?Programming menu?, 108.07 included a timer extension for Programming menu application that had to be installed before the expiration date of 3/27/18. After the expiration, IDS can?t accept the extension. To correct this, uninstall IDS and re-install IDS 108.00 >IDS 108.07 up-date. Select "Remove Mazda data files and settings" as shown below. |
| SA-036-17 | 2017-10-12. Service bulletin. IDS SOFTWARE VERSION 107 AVAILABLE ON MGSS - PLEASE UPDATE YOUR PC'S. Upgrade your PCs to IDS version 107.00 and 107.01 from the previous version. |
| SSPA1 | 2017-09-14. Service bulletin. Mazda Motor Corporation has decided to conduct a Special Service Program (SSP) on certain 2014 Mazda6 vehicles produced from November 8, 2012 through September 27, 2013. On certain 2014 Mazda6 vehicles, a concern has been identified with the software of the vehicle control module (VCM), which controls the Smart Brake Support (SBS) and Mazda Radar Cruise Control (MRCC) features. When the vehicle is driven without stopping for a long time, it is possible that a zero-point of the radar sensor may be inappropriately aligned. Under this condition, the warning light will illuminate and the SBS and MRCC features will stop operating. Dealers are to reprogram the VCM with modified software. The repair must be performed at no charge to the vehicle owner. |
| MT-014-17 | 2017-08-10. Service bulletin. Whenever you are reprogramming a PCM or any other module, always use the GR8 Battery Charger in the Power Supply mode to prevent the battery from discharging. |
| SA-063-17 | 2017-08-10. Service bulletin. Some customers may complain about the "wrong" phone is connected to the infotainment system. MAZDA CONNECT bluetooth will connect all profiles to devices in order of priority if the last device is not available. This concern may be a normal operation of the CMU connecting to available devices on start up. |
| SA-060-17 | 2017-08-10. Service bulletin. Some 2012-2016 Mazda3s, 2013-2015 CX-5s and 2014-2015 Mazda6s may experience the Check Engine Light ON with DTC P0101 and/or P061B and/or driveability problem after reprogramming the PCM using IDS versions 105.02 to 105.04. If the PCM is reprogrammed with any software number included in the attached file and the throttle valve has too much carbon build up, the engine air amount calculation by the problem software may not be accurate. Perform the following Repair Procedure to correct this issue. NOTE Current version of IDS is 106.02. |
| 01-028-13-2858 | 2017-08-10. Service bulletin. Some customers may experience a warning message "i-ELOOP Inspection Required" in the instrument cluster information display while driving. The master warning light will also be illuminated. DTC P1794:00 (Capacitor (i-ELOOP) system: Capacitor (i-ELOOP) malfunction) is stored in PCM memory. |
| 09-007-15-3011 | 2017-05-25. Service bulletin. SOME VEHICLES MAY HAVE THE BLIND SPOT MONITORING (BSM) OFF INDICATOR LIGHT FLASHING AND DTC U3000:54 STORED IN MEMORY. THE CONCERN IS CAUSED BY INADEQUATE BSM CONTROL MODULE CONTROL LOGIC. THE BSM CONTROL MODULE SOFTWARE HAS BEEN UPDATED TO ELIMINATE THIS CONCERN. |
| 09-008-15-2991 | 2017-05-25. Service bulletin. SOME CUSTOMERS MAY COMPLAIN ABOUT ONE OR MORE OF THE FOLLOWING CONCERNS. 1. SMS/TEXT CANNOT BE DOWNLOADED WHEN CONNECTED VIA BLUETOOTH. 2. OPERATIONAL CONCERNS WHEN PLAYING A MEDIA DEVICE (IPOD, USB STICK ETC.) CONNECTED VIA THE USB PORT. A. AFTER THE IGNITION IS TURNED ON, IT TAKES A LONG TIME TO LOAD ALL THE DATA FROM THE DEVICE BEFORE STARTING PLAYBACK. DEPENDING ON THE DATA VOLUME, IT CAN TAKE UP TO SEVERAL MINUTES. B. AFTER THE IGNITION IS TURNED ON, THE PLAYBACK ALWAYS STARTS FROM THE FIRST TRACK. IT DOES NOT START FROM THE LAST PLAYING TRACK/POSITION WHEN THE IGNITION WAS TURNED OFF. THESE CONCERN MAY BE CAUSED BY THE SOFTWARE OF THE BLUETOOTH/HANDS-FREE MODULE THAT CONTROLS THE USB CONNECTION. TO IMPROVE THESE CONCERNS, THE SOFTWARE OF THE BLUETOOTH/HANDS-FREE MODULE HAS BEEN CHANGED. NOTE: THE UPDATED SOFTWARE OF THE BLUETOOTH/HANDS-FREE MODULE WILL ONLY ADDRESS SMS/TEXT CONCERNS FOR THE APPLEĀ® IPHONE AT THIS TIME. |