Service bulletin A17-036
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10108882 |
| Published by NHTSA | 2017-07-31 |
| Manufacturer's number | A17-036 |
| Manufacturer's date | 2017-06-20 |
| NHTSA component | ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR |
NHTSA's summary
Service bulletin - The MIL comes on with DTC P0430 (front bank catalyst system efficiency below threshold [Bank 2]). The PCM software may misinterpret sensor inputs as a deteriorated catalytic converter.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Engine, Exhaust and emissions, Transmission and driveline, Automatic transmission, Catalytic converter, Software, Transmission control module
Trouble codes named
P0430
| HONDA PILOT | 2016 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| A23-073 | 2023-09-13. Service bulletin. Service Bulletin - The vehicle's transmission temperature can become too hot due to automatic transmission fluid deterioration causing high foaming and low viscosity. During extended high load driving, the automatic transmission fluid will foam and cooler flow rate is reduced. |
|---|---|
| ABOM01062023 | 2023-01-11. Service bulletin. Dealer Message - During development, the idle stop enable criteria was mis-set allowing idle stop to improperly engage while battery health is low. Under certain circumstances, after coming to a stop and engaging idle stop, the vehicle may not automatically restart. In most cases, the client can immediately restart the vehicle by selecting Park and pushing the Start button. |
| A23-009 | 2023-01-11. Service bulletin. Service Bulletin - Under certain circumstances, after coming to a stop and engaging idle stop, the vehicle may not restart automatically due to excessive cylinder pressure and/or low cranking torque. Typically, the customer can immediately restart the vehicle by selecting Park and pressing the ENGINE START/STOP button. NOTE: If 23-008 Product Update: PGM-FI Idle Stop Software Update is applicable to the VIN, the PGM-FI software must be updated first before the warranty extension applies. Honda is extending the warranty coverage for valve adjustment and starter replacement related to this condition to 10 years from the original date of purchase with no mileage limitation. |
| A23-008 | 2023-01-11. Service bulletin. Service Bulletin - Under certain circumstances, after coming to a stop and the idle stop feature engages, the vehicle may not automatically restart. Typically, the customer can immediately restart the vehicle by selecting Park and pushing the ENGINE START/STOP button. |
| ATS-151101 V2 | 2021-05-14. Service bulletin. Replacement TCMs don’t come with trim data. After installation, you need to run a teach-in (hydraulic pressure characteristic calibration) procedure with the HDS. The problem is that A/T DTC P287C (transmission adaptive values not learned) is set, which prevents teach-in. This happens because the TCM is programmed to look for trim data any time the ignition is cycled. If the TCM doesn’t see that trim data, it sets A/T DTC P287C. If any DTCs are set, the TCM won’t initiate teach-in and, as a result, can’t learn the trim data. It’s a classic catch-22 situation. |
| SB-15-072 02720 | 2021-05-14. Service bulletin. BACKGROUND There is a software problem within the audio-navigation unit that may cause the display screen, including any video images, to go blank and the unit to stop working |
| JW0-15-074 | 2021-05-13. Service bulletin. During manufacturing, the gauge control module software installed did not meet specification and there are two potential issues: • The gauge control module adds mileage to the odometer when the OFF mode is selected (Touring and Elite only). • The gauge control module loses communication with the HDS or may not transfer the odometer mileage and maintenance minder information when replacing the gauge control module. There is one software update that will repair one or both of the issues affecting your vehicle. |
| JV5-15-072 | 2021-05-13. Service bulletin. Contact any authorized Honda dealer for an appointment to have your vehicles audio-navigation unit software updated. This work will be done free of charge. Please plan to leave your vehicle at the dealer for one full day to allow them flexibility in scheduling |
| A20-100 | 2021-02-18. Service bulletin. "Service Bulletin - The PCM software may misinterpret sensor inputs as a deteriorated catalytic converter. Additionally, debris from the high pressure pump or the fuel injector machining process can cause internal wear or clogging inside one or more injectors. One or more of the following DTCs may be stored: - P0420 (rear bank catalyst system efficiency below threshold [bank 1]) - P0430 (front bank catalyst system efficiency below threshold [bank 2]) - P0300-P0306 (misfire) - P219A (air-fuel ratio variation of cylinder [bank 1, rear bank]) - P219B (air-fuel ratio variation of cylinder [bank 2, front bank]) American Honda is extending the warranty on these repairs to 10 years from the original date of purchase or 150,000 miles, whichever comes first." |
| ABOM11242020 | 2020-12-02. Service bulletin. Dealer Message - The fuel injectors may not have been manufactured to proper specifications. As a result, debris from the high pressure pump or the fuel injector machining process may cause internal wear or clogging inside one or more injectors. Also, the PCM software may misinterpret sensor inputs as deteriorated catalytic converter. |