WenmarOpen by Wenmar Pro

Service bulletin 15-192-16

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10075064
Published by NHTSA2016-06-22
Manufacturer's number15-192-16
Manufacturer's date2016-01-14
NHTSA componentWHEELS

NHTSA's summary

SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Wheels

Vehicles listed
SUBARU OUTBACK2015, 2016

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
05-97-262026-05-04. Service bulletin. This Bulletin provides the diagnostic procedures to be followed when addressing customer concerns of steering wheel/vehicle body vibration when driving at highway speeds when tire/wheel balance is suspected.
15192162023-04-17. Service bulletin. Loose / Gapping Accessory Front Wheel Arch Moldings
05-85-21R2021-05-05. Service bulletin. This bulletin announces a design change made to the TPMS valve assemblies.
05-67-192019-03-11. Service bulletin. This bulletin announces a slight design change made to the sealing areas of the wheel hub assemblies for the models as listed above. The change was made to enhance productivity during the vehicle assembly process.
05-64-182018-08-20. Service bulletin. This Service Information bulletin announces a change made to the rear frame stay mounting flange bolts. The new flange bolts (5 used per side) have been lengthened by 2mm to an overall length of 25mm.
15-192-162016-09-28. Service bulletin. THIS BULLETIN PROVIDES A SERVICE PROCEDURE TO ADDRESS CUSTOMER CONCERNS OF LOOSE OR GAPPING ACCESSORY FRONT WHEEL ARCH MOLDING(S) (E201SAL000 MOLDING KIT). THERE ARE 2 RETAINING CLIPS ON EACH MOLDING WHICH HAVE BEEN IMPROVED TO ENHANCE RETENTION OF THE MOLDING TO THE FENDER LIP THEREBY ELIMINATING ANY GAP BETWEEN THE MOLDING AND THE BODY. THIS BULLETIN APPLIES TO THE FRONT WHEEL ARCH MOLDINGS ONLY.