Service bulletin 08-028-14

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10062149
Published by NHTSA	2016-04-12
Manufacturer's number	08-028-14
Manufacturer's date	2014-03-07
NHTSA component	ELECTRICAL SYSTEM:SOFTWARE

NHTSA's summary

SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Electrical system, Software

Vehicles listed
CHRYSLER 300	2011, 2012
DODGE CHARGER	2011, 2012
DODGE JOURNEY	2011, 2012

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
24-005-17	2022-08-08. Service bulletin. Flash: HVAC Diagnostic and System Improvements This bulletin involves reprogramming the Heating Ventilation Air Conditioning (HVAC) Module with the latest available software. Some customers may notice one of the following:The Defrost button has to be pressed twice to activate the system. The Automatic Temperature Control (ATC)/ Manual Temperature Control (MTC) controller may lose its configuration. This condition can happen when the battery is disconnected or becomes low. This condition could also happen if CAN bus communication was lost. The software was changed to monitor the configuration every two secondsand updated it if the last data saved in memory is different from what is being received on the CAN bus to correct this issue (2011 Only).
08-032-12 REV. A	2022-07-25. Service bulletin. Flash: No Audio From The Radio Caused By The Amplifier Not Communicating This bulletin involves re-flashing the Amplifier with updated software. The customer may indicate that there is no audio and/or radio is muted. This condition may be caused by the amplifier not communicating on the bus.Flashing the amplifier will correct this condition.
21-005-13	2021-03-15. Service bulletin. FLASH: MIL Illumination For P0730 - Incorrect Gear Ratio This bulletin involves updating the Transmission Control Module (TCM) software. Customers may indicate that the MIL is illuminated and/or the transmission went into limp-in. Upon further investigation, Diagnostic Trouble Code (DTC) P0730 - Incorrect Gear Ratio is either active or stored in the PCM?s memory.
08-032-13	2021-03-15. Service bulletin. Flash: No Audio From The Radio Caused By The Amplifier Not Communicating This bulletin involves re-flashing the Amplifier with updated software. The customer may indicate that there is no audio and/or radio is muted. This condition may be caused by the amplifier not communicating on the bus.Flashing the amplifier will correct this condition.
18-067-15 REV A	2019-05-20. Service bulletin. Flash: PCM Software Enhancements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in the Powertrain Control Module (PCM): ? U0140 - Lost Communication With Body Control Module. ? U0401 - Implausible Data Received From ECM/PCM. ? P0441 - Evap Purge System Performance. ? P0340 - Camshaft Position Sensor Circuit - Bank 1 Sensor 1. This software update also has improvements for fuel pump relay cycling during remote starts.
18-085-15	2019-05-20. Service bulletin. Powertrain System Improvements/Enhancements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may describe hearing the fuel pump relay cycling during remote start or a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in the PCM: ? U0140 - Lost Communication With Body Control Module (BCM). ? P06DD - Engine Oil Pressure Control Circuit Stuck Off. ? P0522 - Engine Oil Pressure Sensor Circuit Low. ? P0108 - Manifold Absolute Pressure Sensor Circuit High. ? P1239 - Engine Oil Temperature Too Low. ? P0298 - Engine Oil Temperature Too High.
18-067-15	2018-11-19. Service bulletin. Flash: PCM Software Enhancements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find one of the following Diagnostic Trouble Codes (DTCs) have been set: ? U0401-00 - Implausible Data Received From ECM/PCM ? P0441 - Evap Purge System Performance ? P0340 - Camshaft Position Sensor Circuit - Bank 1 Sensor 1 This software update also has improvements for fuel pump relay cycling during remote starts.
08-010-15	2018-11-19. Service bulletin. Flash: DTC B1A8A-00 - No Start Condition With a Low Battery This bulletin involves reprogramming the Radio Frequency Hub (RF-HUB) with new software. A small number of customers may report no start condition with the Vehicle Security Light flashing and the DTC B1A8A-00 ? MULTI-MODULE VIN HANDSHAKE FAILURE ? active.
08-007-13	2018-06-04. Service bulletin. RB5 RE2 Loss Of satellite Function, No Sirius ID Message This Bulletin involves updating the radio's software or replacing the Telematics Gateway Module (TGM) if required. A customer may experience a loss of satellite radio functions. The customer may note that a message, ? No Sirius ID? is displayed on the screen. Updating the radio software will prevent this condition from occurring . If the customer has lost all satellite radio functions and ?No Sirius ID? is displayed on the screen, the TGM/TGW will need to be replaced to repair this condition. NOTE: All radio and navigation functions are controlled by the TGM.
18-031-12 REV. A	2018-05-14. Service bulletin. Flash: MIL Illumination P0108 - Manifold Absolute Pressure Sensor Circuit High This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that P0108 - Manifold Absolute Pressure Sensor Circuit High has been set active or stored.Updating the software will correct the condition listed above.