# Service bulletin SIB\-63\-10\-14

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10057567
- Published by NHTSA: 2015\-06\-10
- Manufacturer's number: SIB\-63\-10\-14
- Manufacturer's date: 2014\-10\-01
- NHTSA component: EXTERIOR LIGHTING:HEADLIGHTS

## NHTSA's summary

BMW: SOME VEHICLES EXPERIENCING VARIOUS MESSAGE DISPLAYED REGARDING MALFUNCTION OF LED HEADLIGHT, WITH OPTIONS 0552 AND 0524. \*PE

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Lighting, Headlights

## Vehicles listed

- 2014 BMW 428I
- 2014 BMW 428XI
- 2014 BMW 435I
- 2014 BMW 435XI
- 2013 to 2014 BMW 528I
- 2013 BMW 528XI
- 2013 to 2014 BMW 535I
- 2013 BMW 535XI
- 2013 BMW 550I
- 2013 BMW 550XI
- 2013 to 2014 BMW 740I
- 2013 to 2014 BMW 740LI
- 2013 to 2014 BMW 750I
- 2014 BMW 750LI
- 2013 BMW 760LI
- 2013 to 2014 BMW X5

## Other bulletins for the same vehicles and component

- [B630413](/bulletins/10151021.md), 2018-12-10, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS:CONCEALMENT DEVICES; EXTERIOR LIGHTING:HEADLIGHTS. ?This Service Information bulletin supersedes SI B63 04 13 dated February 2013. It designates changes to this revision SUBJECT Moisture in LED Headlight . INFORMATION Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks.
- [630213](/bulletins/10149310.md), 2018-11-26, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. Check Control Message "Automatic Headlight Adjustment Failed". One or more of the following Check Control Messages \(CCM\) will be displayed on the Central Information Display \(CID\): \* Adaptive light system defective \* Front left or right lighting system defective \* Automatic headlight range adjustment defective Additionally, one or more of the following symptoms may occur: \* Both low\-beam headlamps point in the downward direction. \* The turn signal indicator in the KOMBI flashes rapidly. CAUSE Software error in the Footwell Module \(FRM\)
- [621012](/bulletins/10149309.md), 2018-11-26, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. Head\-Up Display Is Too Dark. The Head\-up Display \(HUD\) is too dark. Rain/light/solar/condensation sensor \(RLSB\) hardware error
- [513114](/bulletins/10148420.md), 2018-11-13, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. Headlight Cleaning System: Functional Operation Change. The customer complains that the headlight cleaning system is not working properly and only works after several actuating attempts. CAUSE The "functional" operation of the headlight cleaning system was changed with integration level F020\-14\-07\-500. The functional changes to the headlight cleaning system's operation will occur only after programming the vehicle with ISTA/P 2.53.0 or higher. INFORMATION The headlight cleaning system is no longer activated with the first stalk activation when the lights are on. The functional programming change now requires the stalk to be activated four times before headlight cleaning is activated. The change prevents automatic activation of headlight cleaning when the customer only wants to clean his/her windshield. This is normal operation and no parts should be changed.
- [630814](/bulletins/10148334.md), 2018-11-13, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. Active Headlight Control Malfunction in Both Headlights. AHL \(Active Headlight Control\) malfunctions on both sides. Both lights aim either up or down while driving. Fault Code 8041B6 is present. Broken mounting bolt holding on the rear height sensor bracket.
- [630514](/bulletins/10148039.md), 2018-11-13, Service bulletin: ELECTRICAL SYSTEM; EXTERIOR LIGHTING:HEADLIGHTS; EXTERIOR LIGHTING. "Adaptive Headlight Malfunction in Cold Weather. \* In very cold weather conditions \(32ºF or below\) with the light switch in the automatic position, the CCM \(Check Control Message\) ""Adaptive headlight malfunction"" is displayed. \* When the CC message is displayed, all the lights continue to function. \* When switching the headlights to high beam and the headlight unit is cold, the mechanism inside the headlight is too stiff to move. Software error in TMS 3 \(headlight driver module AHL, xenon headlight\)"
- [630614](/bulletins/10147978.md), 2018-11-13, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS; EQUIPMENT. One or Both Headlights Are Aimed Downwards. The customer may experience one or more of the following complaints: \* One or both headlights are aimed significantly too low \(jammed lower limit\). \* No reference run is visible on the affected headlight when the ignition is turned on and the light switch is in the auto position. \* No CCM \(Check Control Message\) is displayed when a headlight is faulty. CAUSE \* TMS\-3 \(Headlight driver module AHL\) coding error \* Defective mechanism inside the headlight
- [630814](/bulletins/10147925.md), 2018-11-13, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. Active Headlight Control Malfunction in Both Headlights. AHL \(Active Headlight Control\) malfunctions on both sides. Both lights aim either up or down while driving. CAUSE Broken mounting bolt holding on the rear height sensor bracket
- [630115](/bulletins/10147621.md), 2018-11-13, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. "SUBJECT Check Control Message: Adaptive LED Headlight Malfunction. The following CC message is displayed: ""LED Headlight malfunction"" The fault codes listed below are stored in the LHM2 \(LED main light module\) and are not currently present: z LHM2\_L: 8059A9 \- Fan 1 defect z LHM2\_L: 8059AA \- Fan 2 defect z LHM2\_R: 805B29 \- Fan 1 defect z LHM2\_R: 805B2A \- Fan 2 defect Coding error in the LHM2 module"
- [B630516](/bulletins/10146962.md), 2018-11-05, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS:CONCEALMENT DEVICES. "HEADLIGHT ASSEMBLIES HAVE VISIBLE INTERNAL MOISTURE/CONDENSATION. Water on the inside \(A\) or misting \(B\) of both headlight lenses that is visible from outside. Water inside the headlights can be caused by two situations: Water/moisture ingress into the headlight housing. Thermal conditions that result in the formation of condensation. Note: An important indication that the moisture issue is caused by ""condensation"" rather than a ""water leak"" into the headlight housing, there will be misting/condensation in ""both headlights."""

JSON: [/v1/bulletins/10057567](/v1/bulletins/10057567)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20SIB-63-10-14&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10057567&vehicle=Service%20bulletin%20SIB-63-10-14)