# Service bulletin NTB\-14\-100

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10056481
- Published by NHTSA: 2014\-12\-13
- Manufacturer's number: NTB\-14\-100
- Manufacturer's date: 2014\-10\-15
- NHTSA component: AIR BAGS

## NHTSA's summary

NISSAN: WHEN EVER AIR BAG DIAGNOSIS SENSOR UNIT IS REPLACED, IT MUST BE CONFIGURED AND IF NOT, DTC B1427\-55 WILL BE SET, ON CERTAIN VEHICLES. MODEL 2014 ROGUE. \*PE

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Air bags

## Trouble codes named

B1427

## Vehicles listed

- 2014 NISSAN ROGUE

## Recalls for the same vehicles and component

- [16V244000](/recalls/nhtsa/16V244000.md), 2016-04-26: AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION

## Other bulletins for the same vehicles and component

- [NTB19\-071D](/bulletins/11009068.md), 2024-10-22, Service bulletin: AIR BAGS. DTC B00A0\-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0\-00 \(OCCUPANT DETECTION SENSOR UNIT\) is stored, AND OCS zero point reset cannot be performed, \(continued on the next page\)
- [NTB19\-071C](/bulletins/10234044.md), 2023-04-10, Service bulletin: SEATS; AIR BAGS. DTC B00A0\-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [NTB19\-071B](/bulletins/10213158.md), 2022-06-03, Service bulletin: AIR BAGS. DTC B00A0\-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [NTB16\-025](/bulletins/10194201.md), 2021-05-24, Service bulletin: AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION. Air Bag Diagnosis sensor unit coinfiguration
- [NTB14\-100B](/bulletins/10194177.md), 2021-05-24, Service bulletin: EQUIPMENT; AIR BAGS. 2014 Rogue; Configuring the Air Bag Diagnostic sensor Unit
- [NTB00042D](/bulletins/10192513.md), 2021-05-10, Service bulletin: AIR BAGS; BACK OVER PREVENTION; EQUIPMENT. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat\-Mounted Side\-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non\-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
- [NTB08055C](/bulletins/10192305.md), 2021-05-10, Service bulletin: EQUIPMENT; AIR BAGS. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System \(SRS\) safely is included in the "RESTRAINTS" section of the Electronic Service Manual \(ESM\) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
- [NTB19\-071A](/bulletins/10190213.md), 2021-04-13, Service bulletin: AIR BAGS. DTC B00A0\-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [NTB19\-071](/bulletins/10165784.md), 2019-10-09, Service bulletin: ELECTRICAL SYSTEM; AIR BAGS. DTC B00A0\-00 STORED IF YOU CONFIRM DTC B00A0\-00 \(OCCUPANT DETECTION SENSOR UNIT\) is stored And OCS zero point reset cannot be performed \(continued on the next page\) And The following screen displays: ACTION 1. Check the Occupant Classification System \(OCS\) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on page 5. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75\-zero RESET”.
- [NTB16\-025](/bulletins/10075202.md), 2016-06-22, Service bulletin: AIR BAGS. AIR BAG DIAGNOSIS SENSOR UNIT CONFIGURATION SERVICE INFORMATION If an Air Bag Diagnosis Sensor Unit is replaced and the configuration of the old unit could not be saved, use the Service Procedure in this bulletin to: • Load the VIN specific configuration file from your electronic parts catalog \(FAST or equivalent\) onto a portable USB storage device \(thumb drive\). • Plug the thumb drive into your CONSULT PC. • Configure the new Air Bag Diagnosis Sensor Unit using the file that you loaded onto the thumb drive.

JSON: [/v1/bulletins/10056481](/v1/bulletins/10056481)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20NTB-14-100&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10056481&vehicle=Service%20bulletin%20NTB-14-100)