# Service bulletin NTB\-14\-072

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10056134
- Published by NHTSA: 2014\-09\-16
- Manufacturer's number: NTB\-14\-072
- Manufacturer's date: 2014\-07\-30
- NHTSA component: EQUIPMENT ADAPTIVE/MOBILITY; BACK OVER PREVENTION: CAMERA SYSTEM

## NHTSA's summary

NISSAN: USE CORRECTED SPECIFICATION \(SD\) FOR POSITIONING TARGETS WHEN PERFORMING THE CALIBRATION FOR REAR VIEW CAMERA, THAT MONITORS TRAVELING LANE. MODEL 2014 ROGUE.

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Driver assistance, Equipment and accessories, Backup camera

## Vehicles listed

- 2014 NISSAN ROGUE

## Other bulletins for the same vehicles and component

- [NTB13106E](/bulletins/10192813.md), 2021-05-10, Service bulletin: EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM\(GLOBAL POSITIONING SYSTEM\); STEERING; ELECTRICAL SYSTEM; BACK OVER PREVENTION. SERVICE INFORMATION If the configuration of the Audio/Navigation unit has not been completed correctly, some of the symptoms that may occur are: \* Intermittent or no back up camera operation \* No steering wheel switch response to audio inputs \* No volume response from volume knob \* Volume very loud or very quiet and adjustment is overly sensitive \* Equalizer is adjusted so that Bass control is at maximum all the time \* DTC U1000 for AVM C/U could be present If the above symptoms occur: \* Confirm the configuration of the Audio/Navigation unit is correct. NOTE: Correct configuration of the appropriate control unit will restore correct operation. Audio/Navigation unit configuration is outlined starting on page 2. See this bulletin for further detail.
- [NTB16025](/bulletins/10192771.md), 2021-05-10, Service bulletin: EQUIPMENT; BACK OVER PREVENTION; ELECTRICAL SYSTEM. SERVICE INFORMATION If an Air Bag Diagnosis Sensor Unit is replaced and the configuration of the old unit could not be saved, use the Service Procedure in this bulletin to: \- Load the VIN specific configuration file from your electronic parts catalog \(FAST or equivalent\) onto a portable USB storage device \(thumb drive\) \- Plug the thumb drive into your CONSULT PC. \- Configure the new Air Bag Diagnosis Sensor Unit using the file that you loaded onto the thumb drive. See this bulletin for further detail.
- [NTB15062A](/bulletins/10192656.md), 2021-05-10, Service bulletin: STRUCTURE; BACK OVER PREVENTION; EQUIPMENT; SUSPENSION; ELECTRICAL SYSTEM. IF YOU CONFIRM There is a popping noise from either the right or the left front coil springs when turning to the right or left. NOTE: Electronic chassis ears may be helpful in isolating this type of noise. ACTION Replace both front coil springs, strut mount bearings, and all other parts listed under PARTS INFORMATION. Position the coil springs as shown on pages 2\-5. Check the front end alignment, adjust to factory specifications as needed. NOTE: Refer to the Electronic Service Manual \(ESM\), section FSU Front Suspension, for strut coil spring removal, installation, and alignment information. IMPORTANT: The Coil Spring Installation Guidelines section in this bulletin MUST be followed in order for a correct repair to be performed.
- [NTB13088A](/bulletins/10192638.md), 2021-05-10, Service bulletin: BACK OVER PREVENTION; WHEELS; SERVICE BRAKES; LANE DEPARTURE. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System \(TPMS\) and Low Tire Pressure Warning System \(LTPWS\) information for: \- Basic diagnosing of TPMS/LTPWS systems \- Radio frequency interference causing a "No Data" \(C1708, C1709, C1710, C1711\) condition \- Sensor leaks \- Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration \- Air pressure changes with altitude and ambient temperatures \- Aftermarket tire sealers \- Aftermarket wheels \- Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
- [NTB12055E](/bulletins/10192605.md), 2021-05-10, Service bulletin: WHEELS; POWER TRAIN; EQUIPMENT; BACK OVER PREVENTION. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV\-type axles during take\-off/acceleration. ACTION: Apply Molykote M77 grease \(P/N 44003\-7S000\) to the hub bearing surfaces. NOTE: \* Do not remove the axle from the hub or transmission for this bulletin \* Refer to the Electronic Service Manual \(ESM\) for model specific torque specifications. \- For 2007\-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail.
- [NTB15060](/bulletins/10192597.md), 2021-05-10, Service bulletin: SERVICE BRAKES; WHEELS; BACK OVER PREVENTION; STEERING; EQUIPMENT. SERVICE INFORMATION When servicing run flat tires or low profile tires: \- Special equipment and procedures are required to avoid damage. \- Specifically, Tire Pressure Monitor transmitters \(TPMS sensors\) can be damaged when improperly dismounting and mounting tires. \- TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. \- To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. \- Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
- [NTB00042D](/bulletins/10192513.md), 2021-05-10, Service bulletin: AIR BAGS; BACK OVER PREVENTION; EQUIPMENT. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat\-Mounted Side\-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non\-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
- [NTB13\-106G](/bulletins/10190160.md), 2021-04-08, Service bulletin: LANE DEPARTURE:LANE KEEP:NAVIGATION SYSTEM/SOFTWARE; ELECTRICAL SYSTEM; BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CORRECT OPERATION OF AUDIO CONTROLS AND BACK\-UP CAMERA REQUIRES CONFIGURATION WITH C\-III PLUS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.

JSON: [/v1/bulletins/10056134](/v1/bulletins/10056134)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20NTB-14-072&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10056134&vehicle=Service%20bulletin%20NTB-14-072)