WenmarOpen by Wenmar Pro

Service bulletin ITB-10-042-A

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10051685
Published by NHTSA2013-04-01
Manufacturer's numberITB-10-042-A
Manufacturer's date2013-01-28
NHTSA componentENGINE

NHTSA's summary

INFINITI: AT VERY LOW SPEEDS, THERE IS LOW IDLING OR ENGINE HESITATION. MODEL 2009-2010 FX35. *PE

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Engine

Vehicles listed
INFINITI FX352009, 2010

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
ITB140022021-05-10. Service bulletin. SERVICE INFORMATION Replacement Engine Control Modules (ECMs) for many newer Infiniti vehicles are now "Blank" ECMs. Blank ECMs come without software and must be programmed (not reprogrammed) before they will function. See this bulletin for further detail.
ITB11018B2021-05-10. Service bulletin. IF YOU CONFIRM The customer reports any of the following: Engine hesitation at idle or very low speeds, and/or Engine speed drops lower than expected when decelerating or coming to a stop, and/or Engine stops running at idle or very low vehicle speeds (parking lot maneuvers), but can be restarted. NOTE: this incident may occur immediately after an oil change. ACTIONS 1. Refer to Step 2 in the Service Procedure to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. See this bulletin for further detail.
ITB15-024a2021-01-09. Service bulletin. 2005-2015 INFINITI VEHICLES; ECM REPROGRAMMING SERVICE INFORMATION This bulletin is no longer active. Please discard previous versions of ITB15-024.
Revision 1-IEVAP2019-01-07. Service bulletin. OBD II EVAP Tube Warranty Enhancement The update below was sent out to Regions and Retailers in August of this year. We are re-circulating this update to make regional and retailer personnel aware that we are re-notifying clients at this time.
Revision 1-NEVAP2018-10-01. Service bulletin. OBD II EVAP Tube Warranty Enhancement UPDATE August 17, 2018 Please discard earlier versions of this bulletin. The announcement from March 21, 2017 has been revised to include: - Clarification that the refueling concern is extremely hard to fill, not intermittent, and occurs at multiple fueling stations and fuel pumps - Customer expense may be applicable if the vehicle is out of warranty
Revision 1-IEVAP2018-10-01. Service bulletin. OBD II EVAP Tube Warranty Enhancement UPDATE August 17, 2018 Please discard earlier versions of this bulletin The announcement from March 21, 2017 has been revised to include: o Clarification that the refueling concern is extremely hard to fill, not intermittent, and occurs at multiple fueling stations and fuel pumps o Client expense may be applicable if the vehicle is out of warranty
ITB17-0202017-08-01. Service bulletin. 2010 - 2012 FX35; MIL ON WITH DTC P0101 This bulletin applies only to vehicles equipped with V6 engine. IF YOU CONFIRM The MIL is ON with DTC P0101 (MAF SEN/CIRCUIT-B1) stored. and There are no drivability issues. ACTION Clean the throttle valve and chamber of the electronic throttle control actuator.