# Service bulletin SB\-18\-013\-09

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10030707
- Published by NHTSA: 2009\-11\-14
- Manufacturer's number: SB\-18\-013\-09
- Manufacturer's date: 2009\-05\-01
- NHTSA component: ENGINE AND ENGINE COOLING:ENGINE

## NHTSA's summary

JEEP: IN COLD CLIMATES A MIL ILLUMINATION P0123 OR P0222 OR STORED DIAGNOSTIC TROUBLE CODE P0123 OR 00222 AND THE ETC LIGHT ILLUMINATED. THIS INVOLVES REPLACING THE ELECTRONIC THROTTLE BODY AND CLEAN AIR DUCT. \*PE

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Engine

## Trouble codes named

P0123, P0222

## Vehicles listed

- 2007 to 2009 DODGE NITRO
- 2007 to 2009 JEEP GRAND CHEROKEE
- 2007 to 2009 JEEP LIBERTY

## Recalls for the same vehicles and component

- [2008042](/recalls/tc/2008042.md), 2008-02-07: Engine

## Other bulletins for the same vehicles and component

- [9003215](/bulletins/10229181.md), 2023-01-09, Service bulletin: ENGINE AND ENGINE COOLING. Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non\-EGR applications. An EGR Block\-Off Plate \(53032739AA\) must be ordered when installing this Long Block Assembly in a Non\-EGR application. Unless, the EGR Block\-Off Plate is being transferred from the old engine.
- [68332810](/bulletins/10223854.md), 2022-10-17, Service bulletin: ENGINE AND ENGINE COOLING. Service \- Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY \- The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T\-joints.\~ 2. Fill the T\-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2\-mm \[0.063\-in\] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.\~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket\(s\) onto the oil pan flange.\~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2\-mm \[0.063\-in\] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.\~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m \[21 ft. lbs.\].
- [9003215](/bulletins/10223602.md), 2022-10-17, Service bulletin: ENGINE AND ENGINE COOLING. Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non\-EGR applications. An EGR Block\-Off Plate \(53032739AA\) must be ordered when installing this Long Block Assembly in a Non\-EGR application. Unless, the EGR Block\-Off Plate is being transferred from the old engine.
- [9002887](/bulletins/10223599.md), 2022-10-17, Service bulletin: ENGINE AND ENGINE COOLING. Part Description: Valve Body Assembly Issue Description: Valve body design was changed between 2010MY and 2011MY applications. To prevent mix matching valve bodies and solenoid packs the connectors are color coded.\~ Valve bodies with a white connector can be used on 2010, 2009, 2008..., model years. Valve bodies with a gray connector can only be used on 2011, 2012, 2013..., model years.\~ Solenoid packs with a white connector are used with 2010, 2009, 2008..., model years. Solenoid packs with a gray connector are used with 2011, 2012, 2013..., model years.
- [S1709000010RevB](/bulletins/10220687.md), 2022-09-26, Service bulletin: ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR; UNKNOWN OR OTHER. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear \(roller failure\) on one or more cam lobes and that camshaft/lifter replacement is necessary.
- [S1709000010 Rev.](/bulletins/10215879.md), 2022-07-18, Service bulletin: ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear \(roller failure\) on one or more cam lobes and that camshaft/lifter replacement is necessary.
- [S1709000010 RevB](/bulletins/10212290.md), 2022-05-31, Service bulletin: ENGINE AND ENGINE COOLING; ENGINE. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear \(roller failure\) on one or more cam lobes and that camshaft/lifter replacement is necessary.
- [R2118796A](/bulletins/10191460.md), 2021-05-03, Service bulletin: ENGINE AND ENGINE COOLING. Valve Body. These may cause over drive cycling.
- [S1709000010 Rev.](/bulletins/10187058.md), 2021-02-16, Service bulletin: ENGINE AND ENGINE COOLING. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear \(roller failure\) on one or more cam lobes and that camshaft/lifter replacement is necessary.
- [S1121000006 Rev.](/bulletins/10180221.md), 2020-09-28, Service bulletin: ELECTRICAL SYSTEM; ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. \(Revision A\) No Start No Crank ? Starter Will Not Engage And There Are No Related Codes Or Concerns

JSON: [/v1/bulletins/10030707](/v1/bulletins/10030707)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20SB-18-013-09&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10030707&vehicle=Service%20bulletin%20SB-18-013-09)