# Service bulletin 03030

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10021508
- Published by NHTSA: 2007\-05\-10
- Manufacturer's number: 03030
- Manufacturer's date: 2007\-04\-18
- NHTSA component: EXTERIOR LIGHTING

## NHTSA's summary

EXTERIOR LAMP FOGGING. \*KB

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Lighting

## Vehicles listed

- 2001 to 2007 NISSAN ALTIMA
- 2004 to 2007 NISSAN ARMADA
- 2001 to 2007 NISSAN FRONTIER
- 2001 to 2007 NISSAN MAXIMA
- 2003 to 2007 NISSAN MURANO
- 2001 to 2007 NISSAN PATHFINDER
- 2001 to 2002 NISSAN QUEST
- 2004 to 2007 NISSAN QUEST
- 2001 to 2007 NISSAN SENTRA
- 2004 to 2007 NISSAN TITAN
- 2007 NISSAN VERSA
- 2001 to 2007 NISSAN XTERRA

## Recalls for the same vehicles and component

- [2010434](/recalls/tc/2010434.md), 2010-12-07: Lights And Instruments
- [2006279](/recalls/tc/2006279.md), 2006-10-30: Lights And Instruments
- [01V376000](/recalls/nhtsa/01V376000.md), 2001-12-12: EXTERIOR LIGHTING:HEADLIGHTS
- [2001291](/recalls/tc/2001291.md), 2001-12-11: Lights And Instruments
- [2000118](/recalls/tc/2000118.md), 2000-05-16: Lights And Instruments

## Other bulletins for the same vehicles and component

- [NTB05\-057c](/bulletins/10180984.md), 2020-10-08, Service bulletin: EXTERIOR LIGHTING; EQUIPMENT. VOLUNTARY SERVICE CAMPAIGN 2002 – 2003 ALTIMA; HALOGEN HEADLAMP GROUND PLATE KIT Service Campaign ID \# PB135 is no longer active. • Repair orders opened after this bulletin’s published date are no longer eligible for reimbursement under Campaign ID \# PB135. • Please discard all previous versions of NTB05\-057.
- [NTB20\-026](/bulletins/10173563.md), 2020-04-08, Service bulletin: EXTERIOR LIGHTING. 2005\-2019 FRONTIER; HIGH\-MOUNTED STOP LAMP SERVICE PART SERVICE INFORMATION The mounting stud diameter for the high\-mounted stop lamp service part has changed from 5 mm to a 6 mm. If for any reason the high\-mounted stop lamp needs to be replaced, the mounting hole will need to be enlarged to 6.5 mm \(¼ inch\) as follows: 1. Remove the high\-mounted stop lamp. • \- For high\-mounted stop lamp removal, refer to the Electronic Service Manual: Section DRIVER CONTROLS \> EXTERIOR LIGHTING SYSTEM \> REMOVAL AND INSTALLATION \> STOP LAMP. 2. Enlarge the high\-mounted stop lamp’s mounting holes \(see Figure 1 on page 2\) using a 6.5 mm \(¼ inch\) drill bit. NOTICE: To avoid damage to the vehicle, apply light pressure to the drill while drilling. Excessive force may cause the drill bit to penetrate too far and damage the headliner. 3. Apply touch\-up paint to the mounting holes to protect the bare metal. 4. Install the new high\-mounted stop lamp using M6 mounting nuts. Refer to the PARTS INFORMATION on page 2.
- [NTB\-10\-061](/bulletins/10032992.md), 2010-06-22, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. NISSAN: XENON HEAD LAMP SERVICE. A XENON HEADLAMP IS NOT FUNCTIONING BECAUSE OF AN ISSUE INSIDE THE HEADLAMP ASSEMBLY \(AN INTERNAL ISSUE\). IN MOST CASES, REPLACEMENT OF A BULB OR HID CONTROL UNIT WILL SOLVE THE INCIDENT. THIS INCLUDES ALL MODELS WITH XENON HEAD LAMPS. NO MODELS LISTED. \*PE
- [NTB\-03\-074\-C](/bulletins/10032306.md), 2010-03-03, Service bulletin: EXTERIOR LIGHTING:TAIL LIGHTS; EXTERIOR LIGHTING; EXTERIOR LIGHTING:FOG LIGHTS; EXTERIOR LIGHTING:HEADLIGHTS:CONCEALMENT DEVICES; EXTERIOR LIGHTING:HEADLIGHTS. NISSAN: EXTERIOR LAMP FOGGING. OCCASIONALLY WATER IS NOTICED IN THE EXTERIOR LAMPS. THIS IS GENERALLY NOT DUE TO A DEFECT. ALL CURRENT EXTERIOR LAMP ASSEMBLIES ARE VENTED TO THE ATMOSPHERE \(NOT SEALED\). THIS IS NECESSARY TO ALLOW FOR EXPANSION AND CONTRACTION OF AIR FROM TEMPERATURE VARIATIONS \(WARMER OR COLDER\) WITHOUT DAMAGE TO THE LAMP. MOISTURE IN THE AIR SOMETIMES TRAVELS INTO AND OUT OF THE LAMP ASSEMBLY THROUGH THESE VENTS. CERTAIN ENVIRONMENTAL CONDITIONS MAY CAUSE MOISTURE TO CONDENSE. THE FOGGING/CLOUDINESS SHOULD DISAPPEAR OVER TIME WHEN THE LAMP IS IN A DRY ENVIRONMENT. NO MODELS LISTED. \*PE UPDATED 5/7/10. \*PE UPDATED 12/9/13. \*PE
- [NTB08\-009](/bulletins/10024181.md), 2008-03-18, Service bulletin: SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:ABS WARNING LIGHT; EXTERIOR LIGHTING:BRAKE LIGHTS. 2007\-2008 ALTIMA; SPEEDOMETER ISSUES AND/OR ABS AND BRAKE LIGHT ON. \*NJ
- [07061](/bulletins/10022617.md), 2007-09-12, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. VEHICLES ARE GETTING MOISTURE IN THE HEADLAMP. \*KB
- [05057](/bulletins/10015516.md), 2005-07-27, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. CAMPAIGN ANNOUNCEMENT REGARDING SERVICE CAMPAIGN NTB05\-057 \- LOW BEAM HALOGEN HEADLAMP BULB ILLUMINATION FAILURE DUE TO POOR GROUND CONTACT. \*TT CSC WAS RECEIVED. UPDATED 3/21/08. \*NJ
- [04110](/bulletins/10010171.md), 2004-11-05, Service bulletin: EXTERIOR LIGHTING. RUNNING BOARD LIGHTS INOPERATIVE. \*NM
- [04074](/bulletins/10007881.md), 2004-07-14, Service bulletin: EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS. 4WD WARNING LAMP COMES ON INTERMITTENTLY. \*MJ
- [103003](/bulletins/10004592.md), 2003-12-24, Service bulletin: EXTERIOR LIGHTING:HEADLIGHTS. OWNER LETTER FOR THE XENON HEADLIGHT THEFT DETERRENT AND POLICE SUPPORT PROGRAM. \*TT

JSON: [/v1/bulletins/10021508](/v1/bulletins/10021508)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%2003030&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10021508&vehicle=Service%20bulletin%2003030)