# Service bulletin 1100204

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10005986
- Published by NHTSA: 2004\-04\-05
- Manufacturer's number: 1100204
- Manufacturer's date: 2004\-02\-09
- Replaces: 1100204A
- NHTSA component: ENGINE AND ENGINE COOLING:EXHAUST SYSTEM

## NHTSA's summary

EXHAUST DRONE. \*TT THIS BULLETIN SUPERSEDES BULLETIN 11\-002\-04 DATED 02/10/04. \*TT

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Engine, Exhaust and emissions

## Vehicles listed

- 2004 DODGE DURANGO

## Other bulletins for the same vehicles and component

- [9003215](/bulletins/10229181.md), 2023-01-09, Service bulletin: ENGINE AND ENGINE COOLING. Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non\-EGR applications. An EGR Block\-Off Plate \(53032739AA\) must be ordered when installing this Long Block Assembly in a Non\-EGR application. Unless, the EGR Block\-Off Plate is being transferred from the old engine.
- [68332810](/bulletins/10223854.md), 2022-10-17, Service bulletin: ENGINE AND ENGINE COOLING. Service \- Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY \- The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T\-joints.\~ 2. Fill the T\-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2\-mm \[0.063\-in\] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.\~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket\(s\) onto the oil pan flange.\~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2\-mm \[0.063\-in\] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.\~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m \[21 ft. lbs.\].
- [9003215](/bulletins/10223602.md), 2022-10-17, Service bulletin: ENGINE AND ENGINE COOLING. Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non\-EGR applications. An EGR Block\-Off Plate \(53032739AA\) must be ordered when installing this Long Block Assembly in a Non\-EGR application. Unless, the EGR Block\-Off Plate is being transferred from the old engine.
- [R2118796A](/bulletins/10191460.md), 2021-05-03, Service bulletin: ENGINE AND ENGINE COOLING. Valve Body. These may cause over drive cycling.
- [2500108](/bulletins/10024083.md), 2008-03-06, Service bulletin: ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE \(PCV\). POSITIVE CRANKCASE VENTILATION \(PCV\) SYSTEM FREEZES IN EXTREME COLD AMBIENT TEMPERATURES \-\- INVOLVES INSTALLING REVISED PCV SYSTEM COMPONENTS. \*NJ
- [1802406](/bulletins/10020194.md), 2006-08-09, Service bulletin: ENGINE AND ENGINE COOLING:ENGINE. ENGINE CYLINDER MISFIRE OR IGNITION COIL MALFUNCTION DURING HEAVY RAIN OR CAR WASH. \*TT
- [05002](/bulletins/10015075.md), 2005-05-18, Service bulletin: ENGINE AND ENGINE COOLING. NEW WATER PUMP FOR 3.7L ENGINE \- NO LONGER COMMON WITH 4.7L. ADVANCED SERVICE INFORMATION \#05\-002. \*TT
- [1801305](/bulletins/10015058.md), 2005-05-18, Service bulletin: ENGINE AND ENGINE COOLING. IDLE FLUCTUATION/DIAGNOSTIC TROUBLE CODES. \*TT
- [0422](/bulletins/10010567.md), 2004-12-02, Service bulletin: ENGINE AND ENGINE COOLING:ENGINE. 5.7L ENGINE LONG BLOCK REPAIR / REPLACE PROCEDURES. WARRANTY PLANNING \& ADMINISTRATION \*TT
- [04010](/bulletins/10006995.md), 2004-05-21, Service bulletin: ENGINE AND ENGINE COOLING:COOLING SYSTEM:RADIATOR ASSEMBLY. LOWER RADIATOR HOSE CLAMPS THAT MAY NOT BE POSITIONED IN THE PROPER LOCATION. \*TT

JSON: [/v1/bulletins/10005986](/v1/bulletins/10005986)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%201100204&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10005986&vehicle=Service%20bulletin%201100204)