# Service bulletin 04034

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10005975
- Published by NHTSA: 2004\-04\-05
- Manufacturer's number: 04034
- Manufacturer's date: 2004\-03\-08
- NHTSA component: EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.

## NHTSA's summary

DVD PLAYER INOPERATIVE. \*TT

## The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

## Components

Equipment and accessories

## Vehicles listed

- 2004 NISSAN ARMADA
- 2004 NISSAN QUEST
- 2004 NISSAN TITAN

## Other bulletins for the same vehicles and component

- [NTB14033B](/bulletins/10192821.md), 2021-05-10, Service bulletin: EQUIPMENT ADAPTIVE/MOBILITY; POWER TRAIN; EQUIPMENT. SERVICE INFORMATION Replacement 5\-speed rear wheel drive Automatic Transmission \(A/T\) assemblies and replacement control valves \(valve bodies\) now come with blank Transmission Control Modules \(TCMs\). Blank TCMs come without software and must be programmed \(not reprogrammed\) and then configured after they are installed. When ordering a replacement A/T or control valve, use the Nissan electronic parts information systems to obtain the correct software program part number See this bulletin for further detail.
- [NTB09099A](/bulletins/10192805.md), 2021-05-10, Service bulletin: EQUIPMENT:APPLIANCE:AIR CONDITIONER; EQUIPMENT ADAPTIVE/MOBILITY. IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location. ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o\-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O\-ring seal. See this bulletin for further detail.
- [NTB09131B](/bulletins/10192801.md), 2021-05-10, Service bulletin: FORWARD COLLISION AVOIDANCE; EQUIPMENT:OTHER:LABELS. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail.
- [NTB00042D](/bulletins/10192513.md), 2021-05-10, Service bulletin: AIR BAGS; BACK OVER PREVENTION; EQUIPMENT. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat\-Mounted Side\-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non\-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
- [NTB13081A](/bulletins/10192326.md), 2021-05-10, Service bulletin: EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. SERVICE INFORMATION The specifications for the intake and exhaust valves and valve lifter service parts have been changed. \* The valve stem length of both intake and exhaust valve has been increased \(Figure 1\) and are a direct replacement for the shorter style valve. \* The related valve lifter cup has been shortened \(Figure 2\) and the point at which the valve lifter contacts the valve stem has been shortened \(not shown\). These service parts will require that the valve and valve lifter be replaced at the same time. See this bulletin for further details.
- [NTB08055C](/bulletins/10192305.md), 2021-05-10, Service bulletin: EQUIPMENT; AIR BAGS. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System \(SRS\) safely is included in the "RESTRAINTS" section of the Electronic Service Manual \(ESM\) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
- [NTB11005D](/bulletins/10192234.md), 2021-05-10, Service bulletin: EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM\(GLOBAL POSITIONING SYSTEM\). Two methods are used to update/upgrade Navigation Map Data: 1. The customer goes to www.nissannavigation.com and is mailed update disc\(s\) or SD Card and installs data, OR 2. The dealership is mailed update disc\(s\) and the customer must visit the dealership to have data installed. Use the matrix in this bulletin to determine which method is utilized for each Applied Vehicle. See this bulletin for further detail.
- [NTB92123D](/bulletins/10192233.md), 2021-05-10, Service bulletin: WHEELS; EQUIPMENT. Nissan Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating \(clear, chrome, titanium, etc.\), are specifically developed to achieve Nissan design and performance standards. These Original Equipment or Genuine Accessory wheels are subjected to testing to ensure they meet Nissan's standards. Nissan Original Equipment Alloy or Genuine Accessory wheels subjected to aftermarket chroming may no longer continue to meet these standards and may be seriously damaged. Therefore, Nissan most strongly discourages, and recommends that these wheels NEVER be subjected to, aftermarket chroming. See this bulletinfor further detail.
- [NTB04\-053c](/bulletins/10183991.md), 2020-12-09, Service bulletin: ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; STRUCTURE. CUSTOMER SATISFACTION INITIATIVE Service Campaign ID \# B0115, B0122, and B0123 are no longer active. • Repair orders opened after this bulletin’s published date are no longer eligible for reimbursement under Campaign ID \# B0115, B0122, and B0123. • Please discard all previous versions of NTB04\-053.
- [NTB20\-057](/bulletins/10179614.md), 2020-09-11, Service bulletin: EQUIPMENT:MECHANICAL; ENGINE AND ENGINE COOLING. VK56 CONNECTING ROD CAP BOLT SERVICE INFORMATION SERVICE INFORMATION A change has been made to the connecting rod cap bolt service part. The new service part \(B in Figure 1\) is visually different, but is a direct replacement for the original equipment part. IMPORTANT: See page 2 for the procedure to inspect the cap bolt service part for excessive stretch. If replacement of a single connecting rod cap bolt is indicated for any given connecting rod, both connecting rod cap bolts of the affected connecting rod must be replaced as a set.

JSON: [/v1/bulletins/10005975](/v1/bulletins/10005975)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%2004034&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10005975&vehicle=Service%20bulletin%2004034)